The specific use method and process of the motorized winch mill.

How to operate the motorized grinder:

1. Before starting the motorized grinder, the drive clutch of the grinder must be opened first, and the front and rear shift levers must be moved to the neutral position before starting the machine.

2. When the motorized grinder moves the clutch, the action should be fast, otherwise the interlocking brake will not work, which will increase the impact force of the automatic brake pawl. It is not advisable to use too much force when starting the machine, until the pulley can drive the input shaft to rotate without slipping.

3. The transmission clutch must be opened when shifting gears by the motorized winch, otherwise, the gears will be damaged. After shifting, check whether the shifting is firmly engaged to prevent skipping.

4. During the gear shifting process of the motorized grinding mill, if it is difficult to enter the gear, you cannot force the gear into the gear. You can use the hand crank device to help the gear. into the block.

5. The manufacturer of the high-speed winching mill tells you the method of installing the wire rope by the motorized winching mill:

(1) Open the reel clutch, wrap the wire rope end on the reel to tighten, and then close the clutch.

(2) Disassemble the bearing support movable seat at one end of the outer side of the drum, and wrap the wire rope around the drum to tighten.

(3) Winding method of wire rope: from bottom to top, that is, the incoming rope is at the bottom, facing the drum, and winding counterclockwise. the brakes don't work.